32 Operation Section Engine Features and Controls Engine Oil Pressure Sensor Crankshaft Position Sensor and Camshaft Position Sensor Engine oil pressure sensor (14) is an absolute pressure sensor that measures the engine oil pressure in the main oil gallery. The engine oil pressure sensor detects engine oil pressure for diagnostic purposes. The engine oil pressure sensor sends a signal to the ECM. If the ECM does not receive a signal from crankshaft position sensor (10), the “DIAGNOSTIC” lamp will indicate a diagnostic fault code which will be logged in the ECM memory.
Table 5 If the ECM does not receive a signal from the primary speed/timing sensor, the ECM will read the signal from the secondary speed/timing sensor. The ECM continually checks in order to determine if there is a signal from both sensors. If either sensor fails, the faulty sensor should be replaced. Low Oil Pressure Warning Intermittent failure of the sensors will cause erratic engine control. The setpoint is dependent upon the engine speed. The fault will be active and logged only if the engine has been running for more than 15 seconds.
Injection Actuation Pressure Sensor Very Low Oil Pressure Warning Injection actuation pressure sensor (2) provides a signal of the injection actuation pressure to the ECM. The ECM modifies the current to the injection actuation pressure control valve (not shown) in order to control the injection actuation pressure. The desired actuation pressure is based on the following engine parameters: quantity of fuel, injection timing, engine speed, and engine operating mode. The very low oil pressure setpoint is dependent upon the engine speed. If the DERATE mode of the engine monitoring system is selected, the ECM will derate the engine power. The engine horsepower will be limited.
Failure of the Engine Oil Pressure Sensor The ECM will detect failure of the engine oil pressure sensor. The diagnostic lamp warns the user about the status of the engine oil pressure sensor. The engine oil pressure related strategies will be disabled in the event of a failure of the engine oil pressure sensor. A failure of the engine oil pressure sensor will not cause a shutdown of the engine or any horsepower change. Inlet Air Temperature Sensor Inlet air temperature sensor (5) measures the inlet air temperature. A signal is sent to the Electronic Control Module (ECM). The inlet air temperature sensor is also used by the ECM to determine initiation of the Cold Start Strategy.
Table 7 Engine Oil Temperature Sensor Engine oil temperature sensor (8) monitors the temperature of the engine oil. The ECM uses the information from the engine oil temperature sensor in order to adjust the timing of the fuel injection and the pressure of the fuel injection. Throttle Position Sensor The Throttle Position Sensor (TPS) sends a signal to the ECM. The signal from the TPS is required in order to govern engine speed. The throttle position sensor signal is used by the ECM in order to calculate the desired engine speed. The TPS is calibrated during the initial installation of the engine. Table 6 Note: The throttle position sensor is not shown in the illustration.
Engine Oil Pressure Sensor Operating pressure range 0 to 690 kPa (0 to 100 psi) Inlet Air Temperature Sensor Operating temperature range −40 to 120 C (−40 to 258 F) Engine Oil Temperature Sensor Operating temperature range −40 to 120 C (−40 to 258 F)