Caterpillar — Cold Weather Operation

48 Operation Section Cold Weather Operation Cold Weather Operation Quantities of No. 1 diesel fuel are limited. No. 1 diesel fuels are usually available during the months of the winter in the colder climates. During cold weather operation, if No. 1 diesel fuel is not available, use No. 2 diesel fuel, if necessary. i01457051 Radiator Restrictions SMCS Code: 1353; 1396 There are three major differences between No. 1 and No. 2 diesel fuel. No. 1 diesel fuel has the following properties: Caterpillar discourages the use of airflow restriction devices that are mounted in front of radiators. Airflow restriction can cause the following conditions:

Lower cloud point Lower pour point High exhaust temperatures Lower rating of kJ (BTU) per unit volume of fuel Power loss When No. 1 diesel fuel is used, a decrease in power and in fuel efficiency may be noticed. Other operating effects should not be experienced. Excessive fan usage Reduction in fuel economy If an airflow restriction device must be used, the device should have a permanent opening directly in line with the fan hub. The device must have a minimum opening dimension of at least 770 cm 2 The cloud point is the temperature when a cloud of wax crystals begins to form in the fuel. These crystals can cause the fuel filters to plug.

The pour point is the temperature when diesel fuel will thicken. The diesel fuel becomes more resistant to flow through fuel pumps and through fuel lines. (120 in 2 ). A centered opening that is directly in line with the fan hub is specified in order to prevent an interrupted airflow on the fan blades. Interrupted airflow on the fan blades could cause a fan failure. Be aware of these values when diesel fuel is purchased. Anticipate the average ambient temperature within the area that the engine will be operated. Engines that are fueled in one climate may not operate well if the engines are moved to another climate. Problems can result due to changes in temperature.

Caterpillar recommends a warning device for the inlet manifold temperature and/or the installation of an inlet air temperature gauge. The warning device for the inlet manifold temperature should be set at 75 C (167 F). The inlet manifold air temperature should not exceed 75 C (167 F). Temperatures that exceed this limit can cause power loss and potential engine damage. Before troubleshooting for low power or for poor performance in the winter, check the type of fuel that is being used. When No. 2 diesel fuel is used the following components provide a means of minimizing problems in cold weather: i01190421 Fuel and the Effect from Cold Weather Starting aids Engine oil pan heaters SMCS Code:

1000; 1250 Engine coolant heaters The following fuels are the grades that are available for Caterpillar engines: Fuel heaters Fuel line insulation No. 1 No. 2 For more information on cold weather operation, see Operation and Maintenance Manual, SEBU5898, “Cold Weather Recommendations”. Blend of No. 1 and No. 2 No. 2 diesel fuel is the most commonly used fuel. Either No. 1 diesel fuel or a blend of No. 1 and No. 2 is best suited for cold weather operation.