Caterpillar — Cooling System Specifications

64 Maintenance Section Cooling System Specifications NOTICE When using Caterpillar ELC, do not use standard SCA’s or SCA filters. To avoid SCA contamination of an ELC system, remove the SCA filter base and plug off or by-pass the coolant lines. NOTICE Do not leave an empty SCA filter on an ELC system. The filter housing may corrode and leak causing an engine failure. Remove the SCA filter base and plug off or by-pass the coolant lines. ELC Cooling System Cleaning Note: If the cooling system is already using ELC, cleaning agents are not required to be used at the specified coolant change interval.

Cleaning agents are only required if the system has been contaminated by the addition of some other type of coolant or by cooling system damage. 3. Remove the empty SCA filter and remove the filter base. Plug the coolant lines or bypass the coolant lines. 4. Flush the system with clean water in order to remove any debris. Clean water is the only cleaning agent that is required when ELC is drained from the cooling system. 5. Use Caterpillar cleaner to clean the system. Follow the instruction on the label. ELC can be recycled. The drained coolant mixture can be distilled in order to remove the ethylene glycol and the water. The ethylene glycol and the water can be reused.

Consult your Caterpillar dealer for more information. 6. Drain the cleaner into a suitable container. Flush the cooling system with clean water. 7. Fill the cooling system with clean water and operate the engine until the engine is warmed to 49 to 66 C (120 to 150 F). After the cooling system is drained and after the cooling system is refilled, operate the engine while the cooling system filler cap is removed. Operate the engine until the coolant level reaches the normal operating temperature and until the coolant level stabilizes. As needed, add the coolant mixture in order to fill the system to the proper level.

NOTICE Improper or incomplete rinsing of the cooling system can result in damage to copper and other metal com- ponents. To avoid damage to the cooling system, make sure to completely flush the cooling system with clear wa- ter. Continue to flush the system until all signs of the cleaning agent are gone. Changing to Caterpillar ELC To change from heavy-duty coolant/antifreeze to the Caterpillar ELC, perform the following steps: 8. Drain the cooling system into a suitable container and flush the cooling system with clean water. NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, test- ing, adjusting and repair of the product.

Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any compo- nent containing fluids. Note: The cooling system cleaner must be thoroughly flushed from the cooling system. Cooling system cleaner that is left in the system will contaminate the coolant. The cleaner may also corrode the cooling system. Refer to Special Publication, NENG2500, “Caterpillar Tools and Shop Products Guide” for tools and supplies suitable to collect and contain fluids on Caterpillar products. 9. Repeat Steps 7 and 8 until the system is completely clean. 10. Fill the cooling system with the Caterpillar premixed ELC.

Dispose of all fluids according to local regulations and mandates. 11. Attach the Special Publication, PEEP5027, “Label” to the cooling system filler for the engine in order to indicate the use of Caterpillar ELC. 1. Drain the coolant into a suitable container. 2. Dispose of the coolant according to local regulations.