79 Maintenance Section Belt - Inspect Adjustment To maximize the engine performance, inspect the belts for wear and for cracking. Replace belts that are worn or damaged. Alternator Belt For applications that require multiple drive belts, replace the belts in matched sets. Replacing only one belt of a matched set will cause the new belt to carry more load because the older belt is stretched. The additional load on the new belt could cause the new belt to break. If the belts are too loose, vibration causes unnecessary wear on the belts and pulleys. Loose belts may slip enough to cause overheating.
If the belts are too tight, unnecessary stresses are placed on the pulley bearings and on the belts. This may shorten the service life of the components. Remove the belt guard, if equipped. Inspect the condition and adjustment of the alternator belts and accessory drive belts (if equipped). To check the belt tension, apply 110 N (25 lb ft) of force midway between the pulleys. A correctly adjusted belt will deflect 9 mm (0.35 inch) to 15 mm (0.59 inch). If the belt does not require replacement or adjustment, install the belt guard. If the belt requires adjustment or replacement, perform the following procedure to adjust the belt tension.
g00768640 Illustration 32 (1) Nut (2) Adjusting Nut (3) Bolt (4) Nut 1. Slightly loosen mounting bolt (3) and nut (4). 2. Loosen nut (1). 3. Tighten adjusting bolt (2) and mounting bolts (3) and (4). Tighten bolt (1). Refer to the Operation and Maintenance Manual, “Torque Specifications” topic (Maintenance Section). If new belts are installed, check the belt tension again after 30 minutes of engine operation at the rated rpm.