Caterpillar — Maintenance Interval Schedule

82 Maintenance Section Cooling System Coolant (ELC) - Change 4. Start and run the engine at low idle for a minimum of 90 minutes. The coolant temperature should be at least 82 C (180 F). 4. Clean the cooling system filler cap. Inspect the gasket that is on the cooling system filler cap. If the gasket that is on the cooling system filler cap is damaged, discard the old cooling system filler cap and install a new cooling system filler cap. If the gasket that is on the cooling system filler cap is not damaged, perform a pressure test. A 9S-8140 Pressurizing Pump is used to perform the pressure test.

The correct pressure for the cooling system filler cap is stamped on the face of the cooling system filler cap. If the cooling system filler cap does not retain the correct pressure, install a new cooling system filler cap. NOTICE Improper or incomplete rinsing of the cooling system can result in damage to copper and other metal com- ponents. To avoid damage to the cooling system, make sure to completely flush the cooling system with clear wa- ter. Continue to flush the system until all signs of the cleaning agent are gone. 5. Start the engine. Inspect the cooling system for leaks and for proper operating temperature. 5. Stop the engine and allow the engine to cool.

Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. Open the drain valve (if equipped) or remove the cooling system drain plugs. Allow the water to drain. Flush the cooling system with clean water. Close the drain valve (if equipped). Clean the drain plugs. Install the drain plugs. Refer to the Operation and Maintenance Manual, “Torque Specifications” topic (Maintenance Section) for more information on the proper torques. i01206445 Cooling System Coolant (ELC) - Change SMCS Code: 1350-070; 1395-044 Clean the cooling system and flush the cooling system before the recommended maintenance interval if the following conditions exist:

Fill The engine overheats frequently. NOTICE Fill the cooling system no faster than 19 L (5 US gal) per minute to avoid air locks. Foaming is observed. The oil has entered the cooling system and the coolant is contaminated. 1. Fill the cooling system with coolant/antifreeze. Refer to the Operation and Maintenance Manual, “Cooling System Specifications” topic (Maintenance Section) for more information on cooling system specifications. Do not install the cooling system filler cap. The fuel has entered the cooling system and the coolant is contaminated. Note: When the cooling system is cleaned, only clean water is needed when the ELC is drained and replaced. 2.

Start and run the engine at low idle. Increase the engine rpm to 1500 rpm. Run the engine at high idle for one minute in order to purge the air from the cavities of the engine block. Stop the engine. Note: Inspect the water pump and the water temperature regulator after the cooling system has been drained. This is a good opportunity to replace the water pump, the water temperature regulator and the hoses, if necessary. 3. Check the coolant level. Maintain the coolant level within 13 mm (0.5 inch) below the bottom of the pipe for filling. Maintain the coolant level within 13 mm (0.5 inch) to the proper level on the sight glass (if equipped). Drain Pressurized System:

Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure.