. OPERATION EXPLANATION OF COMPONENTS ACCUMULATOR, HANDLING (If equipped) WARNING work equipment, it is possible for the work equipment to move under its own weight. The accumulator is installed in the position shown in the diagram on the right. the screws slowly, and never stand in the direction oil spurts out. 3 - 65 The accumulator is charg ed with high-pressure nitrogen gas, so mistaken operation may cause an explosion, which wi ll lead to serious injury or damage. When handling the accumulator, al ways do as f ollows. The pressure in the co ntrol circuit cannot be completely re moved.
Whe n removing the hydraul ic equipment, do not stand in the direction that the o Loosen the bolts slowl il spurts out when carrying out the o peration Do not disassemble th Do not bring it near fla Do not make holes in i Do not hit it, roll it, or s When disposing of the accumulator, the gas must be rele ased. Please contact your Komatsu distributor to have t his work carried out. The accumulator is a circuit, and when it is i for a short time even a Therefore, if the contro device to store the pressure in the control nstalled, the control circuit can be operated fter the engine is stopped.
l lever is moved in the direction to lower the METHOD OF RELEASING PRESSURE IN OPERATING CIRCUIT ON MACHINE EQUIPPED WI ACCUMULATOR 1. Lower the work eq 2. After stopping the engine, operate control lever full strokes to and right to release pressure insid e the work sure cannot be completely released, so if work equipment circuit is remov ed, loosen