. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from 3 - 66 WALK-AROUND CHECK Before starting the engine, l ook around and under the machine to ch eck for loose nuts and bolts, or leakag e of oil, fuel, or coolant, and check c ondition of the work equipment and hydra ulic system. Also check for l oose wirin g, play, and accumulation of dust at places which high temperatures. Leakage of oil or fuel, or ac cumulation of flammable material around high temperature parts, such as th e engine m uffler or turbocharger, may cause fir e.
bnormality is found, repair it or contact your Komatsu distributor. Check carefully, and if any a bnormality is found, repair it or contact your K D o not get on or off the mac hine from the rear. Using this position is dang erous because it is easy to slip and you ca nnot be seen from the operator's co mpartment. Always use the handrail and step at the side when getting on or o ff the machine. I f th e machine is at an angl e, reposition it level before checking. Perform the following inspe ctions and cleaning every day before star ting engine for the day's wo 1. Check for damage, wea r, play in work equipment, cylinders, link age, and hoses.
Check that there are no cracks, excessive wear, or play in the w ork equipment, cylinders, lin kage, or h oses . If any problem is found, r epair it. 2. Remove dirt and debris from around the engine, battery, and rad iator. f Check for dirt accumulat ed around the engine and radiator.Also c heck for flammable material ( dry leaves , twigs, etc.) around the battery , engine muffler, turbocharger, or other high temperature engine parts. If any dirt or found, remove them. or lammable materials are 3. Check for coolant and o il leakage around the engine i Check for oil leakage fro m the engine and coolant leaks from the c ooling system. If any proble m is found , repair t. 4.
Check for oil leakage of oil from power train case, final drive cas e, hydraulic tank, hoses, an Check that there is no o il leakage. If any problem is found, repair the place where the oil is le Check for leakage of oil from the undercover. Check the ground for traces of oil leakage. 5. Check the undercarriag ollers. r I f any problem is found, 6. Check for problems in h I f any problem is found, 7. Check for problems in g auges and monitor t Check that there is no p roblem in the gauges and monitor in the o perator's cab. If any problem is found, r eplace he parts. Clean off any dirt on the surface.