. OPERATION OPERATION 10 to -30 ° C (50 to -22 ° F) Change 0 to 20 below -30 ° C (22 ° F) 20 3 - 86 7. Wh en the eng ine rotation sta bilizes, return to the low i dle (MIN) position of fuel control dial (1) an d then c arry out warming- REMARK rom OFF left, preheating pilo t lamp ( 3) will l ight up and preheating w ill start. (Preheating continues w hile the s tarting s witch is held at the left .) of the preheating time, see the table in Step 5. ing is being carried out, the preheating pilot lamp (3) lights up to show that preheating is being oes not start with the above operation, wait for about 2 minutes, and repeat steps 3. And 4.
For t he details of the p reheat ing time, see the table in Whil e preheat carri ed out. If the engine d oes not start w ith the above operation, wait for about 2 minutes, and re pea t step s 3. And The relationsh ip between the actuation time of the tur bo protect function and th e engine c oolan t temperature is as fo llows. l control dial is operated within the time given below, the engine speed will not change.
ion Even if the fue l contro l dial is operated within the time given below, the engine speed will not c Turbo pr otect funct The tur bo protect functio n is a fu nction to protect the turb ocharger by keeping the engine speed a t less tha n 1000 rpm im mediately after the engin e is started. Whe n the turb o protec t functi on is actuated, the engin positi on of the fuel control dia Whe n the turbo protect functio n is actuated, the engine speed is held at less than 1000 r pm, even if the fuel control dial i s operate d. Whe n the turbo protect functio n is canceled, the engine speed is set to the speed for the position o f the fuel control dial.
The relationsh turbo protect fu nction a nd the temperature of the engin is as shown in the nex t table. han 10 00 r pm, r egardles s of the