Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION in oil (C): Red range REMARK 6. Check for abnormal exhaust gas color, noise, or vibration. If any found, contact your Komatsu 3 - 89 2. Blade control le ver (2) to the full RAI SE position , then hold lever in position , and operate slowly t o the left tilt relief and tilt relief positio ns for 5 minutes. 3. After this, opera te the blade control le ver (2) full y to the RA position, hold th e lever in position, an d relieve th e left and tilt intermittently .

Next, move the leve r to the LO WER pos and lower the b lade to the ground, th en move t he lever to full FLOAT posi tion, hold the lever in position, and relieve left and right tilt intermittently for 5 m inutes. ol lever ful 4. Lower the blad e to the ground, mov e the contr the FLOAT pos ition (lever stroke en d) and ho ld the lev position for 1 m inute. Next, release t he lever an d check th stays in the FLO AT position. After wa iting for 3 minutes, re the lever to the HOLD position. run is completed, ch eck gauges and cau 5. After warm-up lamps for prope it. Continue to r temperature temperature (A): White rang (B): Green rang lamps for prope r operation.

If any ab normality i s found, re it. Continue to r un the engine at light load until engine coo gauge indicator (3) and Hydraulic gauge (4) fall within t he green r (A): White rang (B): Green rang I f the oil temperatur e in the power train is not raised properly, it will take l onger to accelerate to the maximum s peed. 6. Check for abno distributor. bnormali ty is foun