Komatsu — STOPPING ENGINE

. OPERATION OPERATION STOPPING ENGINE 3 - 90 NOTICE Ifthe engine isabruptly stop ped before it has cooled down, engine life may be drastically shortened. D emergency. o not abruptly stop the engine except for an If the spee engine has overheat d allowing the engine ed, do not stop it abruptly, run to gradually cool down, then sto it at medium p it. 1. P lace fuel control di al (1) in the low idle (MIN) pos ition and run t g he engine at low idl e speed for about 5 minutes to allow it to . to allow it to radually cool down 2. T urn the key in start ing switch (2) to the OFF pos T he engine will stop .

REMARK When the key in starti ng switch (2) is turned to the OFF position, th ut the machine power supply is not cut The power supply is maintained for several secon ds to enable th e controller to sav e the operating condition to memory and shuts down the syste power supply is m condition. m after that. The length of time that the aintained depends on the operating time that the Even when the coolin g fan is being operated in rev erse or in the cleaning mode, th e machine power supply is not cut immediately when th e key in starting switch (2) is turned to the OFF position. The power supply is the hydraulic circuit maintained for seven seconds to protect .

During that time, the fan operation the monitor panel flashes. th confirmation lamp on the monitor panel flashes. 3. Remove the key fro