. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST CHECKING 4 - 48 The eflection (0.51 to 0.63 in ) when pressed by thumb (a pprox.10 kg (2 at a point midw ay between the drive pulley and alternator pulley ADJUSTING 1. L a 2. a 1. L oosen bol ts (1) and nuts ( 2), (4), and (5 ), then turn nu djust the b elt tension. 2. After adjust ing, tighten bolt s and n uts (2) , (4), and (5), t lternator ( 3) in position. REMARK Check each pulley for dam age, wear of t he V-groove, and wear of the V-belt. In particul ar, be sure to check that th e V-belt is not touching th e bottom of t he V-groove.
If any pulley is defective, a sk your Koma tsu distributor to replac If any belt h as stretched a nd ther replace both belts at the sa When adjus ting the V-belt, do not push th e tension pull ey directly with a steel bar, etc., b ut put a wood piece, etc. between the pulley and bar . perate for 1 hour, then check and adjust the belt tension again. After replaci ng the V-belt, o perate for 1 hour, then che ck and adjust the belt tension ag