. MAINTENANCE SERVICE PROCEDURE EVERY 500 HOURS SERVICE Maintenance for every 50 and 250 hours service should be carried out at the same time. REPLACE FUEL FILTER CARTRIDGE WARNING Prepare a filter wrench and a container to catch the fuel. NOTICE When filling the filter cartridge with fuel, carry out the filling operation with cap (A) fitted. Cap (A) acts to prevent the entry of dirt or dust into the filter cartridge. 4. Fill the filter cartridge with clean fuel through the 8 small holes (B) in the new filter cartridge. 5. Coat the packing surface of the filter cartridge with oil. 6. Remove filter cartridge cap (A) and install to the filter holder.
4 - 52 After the engine has been operated, all parts are at high temperature, so do not r eplace the filter immediately. Wait for all parts to cool down before starting the operation. ne is running. High pressure is generated inside the engine fuel piping system when the engi When replacing the filter, wait for at least 30 seconds after stopping the engin replacing the filter. Do not bring any fire or flame close. e to let the internal pressure go down before NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has highly effici ent filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part.
The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may system. Always avoid using substitute parts. get in and cause problems with the injection When carrying out inspection or maintenance of the fuel system, pay more atte ntion than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. 1. Set the container under the filter cartridge to catch the drained oil. 2. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 3. Clean the filter holder.