Komatsu — REPLACE FUEL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE with 4 - 53 7. When installing, tighten until the packing surface contacts the seal surface of the filter hold er, then tighten it up 1/2 to 3/4 of a turn. If the filter cartridge is ti ghtened too far, the packing w ill be damaged and this will lead to le akage of fuel. If the filter cartridge is too loo se, fuel will also leak fro m the packing, so always tighten to the co 8. After replacing filter cart ridge (1), loosen air blee d plu g (2) 9. Loosen the knob of prim ing pump (3), then pump the k nob u no more bubbles come out of air bleed plug (2). Tighten air bleed plug ( 11. Loosen air bleeder (4) o 12.

Pump priming pump (3) ome the fuel from air bleeder Tightening torque: 4.9 t lbft) the fuel from air bleeder (4), then tighten air bleeder ( Tightening torque: 4.9 t .6 to 13. Continue pumping (app rox. 50 times) until the priming pump (3) becomes stiff and the overflow valve release ous. g pump (3) in and tighten it. rimin g pump (3) becomes stiff and the ov erflow valve release sound becomes continu 14. Push the knob of primin g pump (3) in and tighte 15. After replacing the filter cartridge, start the engin e and check that there is no leakage of fu el from the filter seal surface. If there is any l eakage of fuel, check the tightenin g of the filter cartridge.

If there is still leakage of fuel, follow Step 1 and 2 to re move the filter cartridge, t hen c hec k the packing surface for damag e or foreign material. If any damage or foreign material is found in the p ackin g, replace the cartridge with a new pa rt, then repeat Steps 3 - 12 to install the filter cartridge.