. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 4 - 54 Refill capacity: 38 liters Prepare a socket wren 1. Remove the cover (1) on the bottom of the machine and set a container to catch the drained oil directly under the d rain plug. 2. Loosen drain plug (P) (with a slit) slowly to avoid get ting oil on yourself, and drain the oil. oil, and if there are excessive metal aterial, please contact your Komatsu 3.
Check the drained particles or foreign m distributor. Install drain plug (P). 4. 5. Open the engine side cover on the left side of the c hassis. 6. Using the filter wrench , turn engine oil filter cartridge (2) to the 7. left and remove it. Clean the filter holde engine oil, coat the thr r, fill the new filter cartridge with clean ead and packing surface of the new filter 8. cartridge with clean e then install it to the filt When installing the fil ngine oil (or coat it thinly with grease), er holder. ter cartridge, bring the packing surface into contact with the fil ter holder, then tighten a furth er 3/4 to 1 turn. After replacing the filt er cartridge, add engine oil through oil 9.
filler port (F) so that th e oil level is between the H an d L marks on dipstick (G). 10. Run the engine at idlin g for a short time, then stop th e engine, and check that the oil l evel is between the H and L ma rks on the dipstick. For details, s ee "CHECK OIL LEVEL IN EN GINE OIL PAN, ADD OIL (PAG E 3-68)".