. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE 4 - 60 1. Screw in 2 valves (1) at th e top of the c orrosio 2. Using a filt er wrench, turn cartridge (2) t o the l eft to remove i Apply engi install it to When inst ne oil to the sea the filter holder.
alling, screw in c with sealin Open valv Use Koma g surface, then es (1) (2 places) tsu genuine car CHECK ALL TIGHTENING PARTS OF TURBOCHARGER Contac t your K omatsu distribu tor to have th e tightening portions CHECK PLAY OF TURBOCHARGER ROTOR Contac t your K omatsu distribu tor to have th e rotor play checked CHECK FOR LOOSE ROPS MOUNT BOLTS Check t hat the bolts are not lo ose and that t here is no If any b olt is lo ose, tighten it to the following torque If there is any damage, replac e the bolt with a genuine Komatsu part. Tightening tor que: 785 to 980 N·m (80 to 10 0 kgf· m, 578.6 to 723.3 lbft)