. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE OIL FILTER ELEMENT WARNING the engine is stopped, and may cause burns. Wait for the 4 - 61 EVERY 2000 HOURS S Maintenance for every 50, 25 0, 500 and 1000 hours serv ice should be carried out at the sa The temperature to go down befor When re moving the oil filler c ap, turn it slowly to release the Refill c apacity: 55 liters (1 4.53 US gal) 1. Lowe r the work equipme nt to the ground, then stop th e engine. 2. Turn the cap of oil fille r (F) slowly to release the internal e cap. the bottom of the hydraulic tank. drain the oil, tighten drain valve (2) pressure, then remove th 3.
Remove the cover (1) at the bottom of the hydraulic t 4. Loose n drain valve (2), drain the oil, tighten drain 5. 6. again , then install cover ( 1). When loosening drain val ve (2), be careful not to get oil on y Remove bolt (3), then re Take out spring (5), valv 7. 8. 9. Clean (6). Install Install 10. Refill the specified quant ity of oil through oil filler (F). 11. Chec k that the oil is at the specified level. For det "CHECK OIL LEVEL IN H YDRAULIC TANK, ADD OI L (PAGE 4-45)" .