Aegis LH630-775 — Section 8 - Electrical System

Section 8 Electrical System and Components 8.12 Electric Starting Motors NOTE: If the starter does not crank the engine, shut These engines utilize solenoid shift style starter off the starter immediately. Do not make motors for dependable operation. Operation, service further attempts to start the engine until the and troubleshooting of the starter and starter system condition is corrected. follow in this section. NOTE: Do not drop the starter or strike the starter Starting Motor Precautions frame. Doing so can damage the starter. NOTE: Do not crank the engine continuously for more than 10 seconds at a time.

If the engine Starter Removal and Installation does not start, allow a 60 second cool-down Refer to the “Disassembly” and “Reassembly” period between starting attempts. Failure to Sections for starter removal and installation follow these guidelines can burn out the procedures. starter motor. Use the exploded view (Figure 8-26) for reference NOTE: If the engine develops sufficient speed to during the disassembly and reassembly procedure. disengage the starter pinion but does not keep running (a false start), the engine rotation must be allowed to come to a complete stop before attempting to restart the engine.

If the starter is engaged while the flywheel is rotating, the starter pinion and flywheel ring gear may clash, resulting in damage to the starter. Troubleshooting Guide – Starting Difficulties Problem Possible Fault Correction Starter Does Not Energize Battery 1. Check the specific gravity of battery. If low, recharge or replace battery as necessary. Wiring 1. Clean corroded connections and tighten loose connections. 2. Replace wires in poor condition and with frayed or broken insulation. Starter Switch or Solenoid 1. Bypass the switch or solenoid with a jumper wire. If starter cranks normally, replace the faulty component. Solenoid Shift Starters: Perform individual solenoid test procedure.

See pages 8.21 and 8.22. Starter Energizes But Turns Slowly Battery 1. Check the specific gravity of battery. If low, recharge or replace battery as necessary. 2. Battery too small, must be at least 400 cold cranking amps . Brushes 1. Check for excessively dirty or worn brushes and commutator. Clean using a coarse cloth (not emery cloth). 2. Replace brushes if excessively or unevenly worn. Transmission or Engine 1. Make sure the clutch or transmission is disengaged or placed in neutral. This is especially important on equipment with hydrostatic drive. The transmission must be exactly in neutral to prevent resistance which could keep the engine from starting. 2.

Check for seized engine components such as the bearings, connecting rod, and piston.