Aegis LH630-775 — Section 8 - Electrical System

Section 8 Electrical System and Components Delco-Remy Starters 3. If the solenoid was mounted with Phillips head screws, separate the solenoid and plunger spring from the drive end cap. If the solenoid was mounted with external Torx head screws, the plunger is part of the solenoid, unhook the plunger pin from the drive lever. Remove the gasket from the recess in the housing. See Figures 8-17 and 8-18. NOTE: Test procedure for checking starter solenoid on pages 8.21 and 8.22. Figure 8-15. Completed Delco-Remy Starter. Starter Disassembly 1. Remove the hex nut and disconnect the positive (+) brush lead/bracket from the solenoid terminal. 2.

Remove the three screws securing the solenoid to the starter. See Figure 8-16. Phillips Head Screws Figure 8-17. Solenoid Removed from Starter. Torx Head Screws Figure 8-16. Removing Solenoid Screws. Figure 8-18. Removing Plunger. 8.13 8