Section 10 Inspection and Reconditioning 6 mm (0.24 in.) Measure 6 mm Above the Bottom of Piston Skirt at Right Angles to Piston Pin. Figure 10-4. Measuring Piston Diameter. Figure 10-5. Checking Cylinder Head Flatness. 2. Use an inside micrometer, telescoping gauge, or bore gauge and measure the cylinder bore. Take the measurement approximately 63.5 mm (2.5 in.) below the top of the bore and perpendicular to the piston pin. Carefully inspect the valve mechanism parts. Inspect the valve springs and related hardware for excessive wear or distortion. Check the valves and valve seat area or inserts for evidence of deep pitting, cracks, or distortion.
Check clearance of the valve stems in guides. See Figure 10-6 for valve details and specifications. 3. Piston-to-bore clearance is the difference between the bore diameter and the piston diameter (step 2 minus step 1). Flywheel Inspection Inspect the flywheel for cracks, and the flywheel keyway for damage. Replace flywheel if cracked. Replace the flywheel, the crankshaft, and the key if flywheel key is sheared or the keyway is damaged. Inspect the ring gear for cracks or damage. Kohler does not provide ring gears as a serviceable part. Replace the flywheel if the ring gear is damaged. Check the charging system magnets to be sure they are not loose or cracked.
Cylinder Head and Valves Inspection and Service After cleaning, check the flatness of the cylinder head and the corresponding top surface of the crankcase, using a surface plate or piece of glass and feeler gauge as shown in Figure 10-5. The maximum allowable out of flatness is 0.076 mm (0.003 in.) . 10.4