Section 10 Inspection and Reconditioning Honing While most commercially available cylinder hones can be used with either portable drills or drill presses, the use of a low speed drill press is preferred as it facilitates more accurate alignment of the bore in relation to the crankshaft crossbore. Honing is best accomplished at a drill speed of about 250 RPM and 60 strokes per minute. After installing coarse stones in hone, proceed as follows: 4. After resizing, check the bore for roundness, taper, and size. Use an inside micrometer, telescoping gauge, or bore gauge to take measurements. The measurements should be taken at three locations in the cylinder-at the top, middle, and bottom.
Two measurements should be taken (perpendicular to each other) at each of the three locations. 1. Lower hone into bore and after centering, adjust so that the stones are in contact with the cylinder wall. Use of a commercial cutting- cooling agent is recommended. Clean Cylinder Bore After Honing Proper cleaning of the cylinder walls following boring and/or honing is very critical to a successful overhaul. Machining grit left in the cylinder bore can destroy an engine in less than one hour of operation after a rebuild. 2. With the lower edge of each stone positioned even with the lowest edge of the bore, start drill and honing process.
Move the hone up and down while resizing to prevent the formation of cutting ridges. Check the size frequently. The final cleaning operation should always be a thorough scrubbing with a brush and hot, soapy water. Use a strong detergent that is capable of breaking down the machining oil while maintaining a good level of suds. If the suds break down during cleaning, discard the dirty water and start again with more hot water and detergent. Following the scrubbing, rinse the cylinder with very hot, clear water, dry it completely, and apply a light coating of engine oil to prevent rusting. 3.
When the bore is within 0.064 mm (0.0025 in.) of desired size, remove the coarse stones and replace with burnishing stones. Continue with the burnishing stones until within 0.013 mm (0.0005 in.) of desired size and then use finish stones (220-280 grit) and polish to final size. A crosshatch should be observed if honing is done correctly. The crosshatch should intersect at approximately 23-33° off the horizontal. Too flat an angle could cause the rings to skip and wear excessively, too steep an angle will result in high oil consumption. See Figure 10-3.
Measuring Piston-to-Bore Clearance Before installing the piston into the cylinder bore, it is necessary that the clearance be accurately checked. This step is often overlooked, and if the clearances are not within specifications, engine failure will usually result. NOTE: Do not use a feeler gauge to measure piston- to-bore clearance–it will yield inaccurate measurements. Always use a micrometer. 10 Use the following procedure to accurately measure the piston-to-bore clearance: 1. Use a micrometer and measure the diameter of the piston 6 mm (0.24 in.) above the bottom of the piston skirt and perpendicular to the piston pin. See Figure 10-4. Figure 10-3. Cylinder Bore Crosshatch After Honing.
10.3