Aegis LH630-775 — Section 10 - Inspection and Reconditioning

Section 10 Inspection and Reconditioning NOTE: If the crankpin is reground, visually check to ensure that the fillet blends smoothly with the crankpin surface. See Figure 10-1. 3. Tighten the self-tapping screw until it draws the plug out of the crankshaft. Procedure to Install New Plug: 1. Use a single cylinder camshaft pin, Kohler Part No. 47 380 09-S , as a driver and tap the plug into the plug bore until it seats at the bottom of the bore. Make sure the plug is tapped in evenly to prevent leakage.

High Point From Fillet Intersections The Fillet Must Blend Smoothly With The Bearing Journal Surface Minimum 45° Crankcase These engines contain a cast-iron cylinder liner that may be reconditioned as follows: This Fillet Area Must Be Completely Smooth Inspection and Service Check all gasket surfaces to make sure they are free of gasket fragments. Gasket surfaces must also be free of deep scratches or nicks. Figure 10-1. Crankpin Fillets. When grinding a crankshaft, grinding stone deposits can get caught in oil passages which could cause severe engine damage.

Removing the crankpin plug each time the crankshaft is ground provides easy access for cleaning any grinding deposits that may collect in the oil passages. Inspect the main bearing (if so equipped) for wear or damage (refer to Section 1, "Specifications, Tolerances, and Special Torque Values"). Replace the crankcase using a mini-block or short block if required. Check the cylinder bore for scoring. In severe cases, unburned fuel can cause scuffing and scoring of the cylinder wall. It washes the necessary lubricating oils off the piston and cylinder wall. As raw fuel seeps down the cylinder wall, the piston rings make metal to metal contact with the wall.

Scoring of the cylinder wall can also be caused by localized hot spots resulting from a cooling system problem or from inadequate or contaminated lubrication. Use the following procedure to remove and replace the plug. Procedure to Remove Crankshaft Plug: 1. Drill a 3/16" hole through the plug in the crankshaft. 2. Thread a 3/4" or 1" long self-tapping screw with a flat washer into the drilled hole. The flat washer must be large enough to seat against the shoulder of the plug bore. See Figure 10-2. If the cylinder bore is badly scored, excessively worn, tapered, or out-of-round, resizing is necessary.

Use an inside micrometer to determine amount of wear (refer to the “Specifications, Tolerances, and Special Torque Values”, in Section 1), then select the nearest suitable oversize of either 0.08 mm (0.003 in.), 0.25 mm (0.010 in.), or 0.50 mm (0.020 in.) . Resizing to one of these oversizes will allow usage of the available oversize piston and ring assemblies. Initially, resize using a boring bar, then use the following procedures for honing the cylinder. Flat Washer Self-Tapping Screw Plug NOTE: If the bore is beyond the wear limit, a new miniblock or short block will be required. Crankshaft Figure 10-2. Removing Crankpin Plug. 10.2 34 12 56 123456 123456 123456