Section 10 Inspection and Reconditioning 2. Remove the oil pump assembly from the closure plate. Figure 10-13. Removing Governor Gear. 2. Remove the locking tab thrust washer located under the governor assembly. Figure 10-15. Removing Oil Pump and Oil Pickup. 3. Remove the oil pump rotor. 3. Carefully inspect the governor gear shaft and replace it only if it is damaged. After pulling damaged shaft, press or lightly tap replacement shaft into closure plate to depth shown in Figure 10-14. 4. Remove the oil pickup by unhooking the locking clip, and pulling it free from the oil pump body. 5.
If the relief valve is a one-piece style, staked to the oil pump housing (See Figure 10-16) removal should not be attempted, nor is internal servicing possible. If a problem with the relief valve is encountered, the oil pump should be replaced. Governor Gear Shaft 19.40 mm (0.7368 in.) 34.0 mm (1.3386 in.) 33.5 mm (1.3189 in.) Figure 10-14. Governor Shaft Press Depth. Reassembly 1. Install the locking tab thrust washer on the governor gear shaft with the tab down. Pickup Relief Valve Figure 10-16. Oil Pump, Oil Pickup, and One-Piece Relief Valve. 2. Position the regulating pin to the governor gear/ flyweight assembly and slide both onto the governor shaft.
Inspection Inspect the oil pump housing, gear, and rotors for nicks, burrs, wear, or any visible damage. If any parts are worn or damaged, replace oil pump. Oil Pump Assembly Disassembly 1. Remove the two hex flange screws. 10.12