Section 10 Inspection and Reconditioning Reassembly 1. Install the oil pickup to the oil pump body. Lubricate the O-Ring with oil and make sure it remains in the groove as the pickup is being installed. 2.0 mm (0.0787 in.) Governor Cross Shaft Seal 2. Install the rotor. 3. Install the oil pump body to the closure plate and secure with the two hex flange screws. Torque the hex flange screws as follows: a. Install fastener into location No. 1 and lightly tighten to position pump. b. Install fastener into location No. 2 and fully torque to the recommended value. Figure 10-17. Governor Cross Shaft Oil Seal Position. c. Torque fastener in location No. 1 to the recommended value.
Oil Pump Torque Sequence Figure 10-18. Governor Shaft Seal Installed. First Time Installation:10.7 N·m (95 in. lb.) All Reinstallations: 6.7 N·m (60 in. lb.) Water Pump The water/coolant pump consists of a sealed impeller assembly, which includes the outer cover and a cogged drive pulley. When the pump is mounted to the crankcase, the impeller fits into a cast recess, and the cover seals against an O-Ring outside the perimeter of the recess. See Figure 10-19. 10 4. After torquing, rotate the gear and check for freedom of movement. Make sure there is no binding. If binding occurs, loosen the screws, reposition the pump, retorque the hex flange screws and recheck the movement.
Governor Cross Shaft Oil Seal If the governor cross shaft seal is damaged and/or leaks, replace it using the following procedure. Remove the oil seal from the crankcase and replace it with a new one. Install the new seal to depth shown in Figure 10-17. 10.13