Aegis LH630-775 — Section 10 - Inspection and Reconditioning

Section 10 Inspection and Reconditioning Figure 10-19. Water Pump. Figure 10-20. Front View of Engine Cooling System. The impeller assembly is not serviceable, but it should be inspected for wear or damage. Inspect the components carefully for signs of wear or damage. 1. Inspect the impeller to make sure the blades are in good condition and free of any cracks, nicks, or damage. 1. Inspect the fan to make sure the blades are in good condition and free of any cracks, nicks, or damage. The area around the fan mounting holes must also be free of any cracks or damage. 2.

The impeller shaft should rotate smoothly, without binding or wobbling, and there should be no sign that coolant has leaked past the shaft to the outer surface of the cover. 3. Check that the drive pulley is not cracked or damaged in any way. If your inspection causes you to doubt its reliability, the water pump assembly should be replaced. Always use a new O-Ring whenever the water pump is removed. Do not reuse the old O-Ring or try to use RTV in its place. Cooling Fan and Drive The cooling fan assembly consists of a fan attached to a v-pulley and bearing carrier (hub), rotating on a dual ball-bearing fan shaft (arbor).

The assembly is mounted with a bracket to the intake manifold and driven via a split pulley off the flywheel. See Figure 10-20. Figure 10-21. Fan Assembly (Pulley Side). 2. The fan and hub assembly, when mounted to the center arbor shaft, must rotate smoothly without noticeable bearing play, wobble, or binding. 3. Check the v-belt for excessive wear, cracking or damage. If proper belt tension cannot be obtained, or the condition of the belt is suspect; replace it with Kohler Part No. 66 203 02-S . Do not use a substitute belt. 10.14