Section 11 Reassembly Section 11 Reassembly General NOTE: Make sure the engine is assembled using all specified torque values, tightening sequences and clearances. Failure to observe specifications could cause severe engine wear or damage. Always use new gaskets. Apply a small amount of oil to the threads of critical fasteners before assembly, unless a Sealant or Loctite ® is specified or preapplied. 3. Install crankshaft. 4. Install connecting rods with pistons and rings. 5. Install camshaft. 6. Check camshaft end play. 7. Install closure plate assembly. 8. Install cylinder studs. 9. Install reed and breather cover assembly. 10. Install hydraulic lifters. 11.
Assemble and install cylinder heads. 12. Install push rods and rocker arms. 13. Install valve covers. 14. Install coolant drain plugs. 15. Install water pump, drive belt, and transfer tube assembly. 16. Install intake manifold assembly. 17. Install stator assembly. 18. Install starter adapter. 19. Install flywheel. 20. Install ignition modules. 21. Install spark plugs. 22. Install starter assembly. 23. Install carburetor and adapter. 24. Install external governor controls and main control bracket. 25. Install lower crankshaft pulley, pulley adapter, and cooling fan assembly. 26. Install air cleaner assembly. 27. Install radiator assembly. 28.
Install flywheel cover, rectifier-regulator and mounting plate. 29. Install muffler. 30. Install oil filter and fill crankcase with oil. 31. Install coolant. 32. Connect battery cables and spark plug leads. Make sure all traces of any cleaner are removed before the engine is assembled and placed into operation. Even small amounts of these cleaners can quickly break down the lubricating properties of engine oil. Check the closure plate, crankcase, cylinder heads, and valve covers to be certain that all old sealing material has been removed. Use gasket remover, lacquer thinner, or paint remover to remove any remaining traces.
Clean the surfaces with isopropyl alcohol, acetone, lacquer thinner, or electrical contact cleaner. Typical Reassembly Sequence The following sequence is suggested for complete engine reassembly. This procedure assumes that all components are new or have been reconditioned, and all component subassembly work has been completed. The sequence may vary to accommodate options or special equipment. Detailed procedures follow: 11 1. Install flywheel end oil seal and camshaft seal. 2. Install governor cross shaft. 11.1