Section 11 Reassembly Install Flywheel End Oil Seal and Camshaft Oil Seal 1. Check to make sure that there are no nicks or burrs in the crankshaft and camshaft seal bores of the crankcase. Install Governor Cross Shaft 1. Lubricate the governor cross shaft bearing surfaces in the crankcase with engine oil. Apply a small amount of grease to the lips of the oil seal. 2. Apply a light coat of engine oil to the outside diameter of the flywheel end oil seal. 2. Slide the small lower washer onto the governor cross shaft and install the cross shaft from the inside of the crankcase. See Figure 11-3. 3. Install the oil seal into the crankcase using a seal driver.
Make sure the oil seal is installed straight and true in bore, until the tool bottoms against the crankcase. See Figure 11-1. Figure 11-3. Installing Governor Shaft. 3. Install the nylon washer onto the governor cross shaft, then start the push-on retaining ring. Hold the governor shaft up in position, then place a 0.25 mm (0.010 in.) feeler gauge on top of the nylon washer, and push the retaining ring down the shaft to secure. Remove the feeler gauge, which will have established the proper end play. See Figure 11-4. Figure 11-1. Installing Crankshaft PTO Side Seal Using Tool. 4. Apply a light coat of engine oil to the outside diameter of the camshaft oil seal. 5.
Install the camshaft oil seal to a depth of 1.0-1.5 mm (0.039-0.059 in.) below the top of the seal bore. See Figure 11-2. Do not bottom the seal in the bore or the oil passage may be obstructed. Figure 11-4. Setting End Play of Governor Shaft. 4. Pivot the governor cross shaft so the bottom end faces the #1 side cylinder. Figure 11-2. Installing Camshaft Seal. 11.2