Section 11 Reassembly Install Crankshaft 1. Lightly lubricate the lips of crankshaft seal with grease. NOTE: Apply cellophane tape over the crankshaft keyway to prevent cutting the oil seal during installation. 2. Carefully slide the flywheel end of the crankshaft into the crankcase through the oil seal. See Figure 11-5. Cylinder #2 Cylinder #1 Figure 11-6. Piston, Connecting Rod and End Cap Detail. 2. Lubricate the cylinder bore, piston, and piston rings with engine oil. Compress the rings of the #1 piston using a piston ring compressor. 3. Lubricate the crankshaft journals and connecting rod bearing surfaces with engine oil. 4.
Make sure the "FLY" stamping on the pistons is facing towards the flywheel side of the engine. Use a hammer with rubber grip and gently tap the piston down into cylinder as shown in Figure 11-7. Be careful that oil ring rails do not spring free, between the bottom of the ring compressor and the top of the cylinder. Figure 11-5. Installing Crankshaft. Install Connecting Rods with Pistons and Rings NOTE: The cylinders are numbered on the crankcase. Make sure to install the piston, connecting rod and end cap into its appropriate cylinder bore, as previously marked at time of disassembly. Do not mix the end caps and connecting rods. NOTE:
Proper orientation of the piston/connecting rod assemblies inside the engine is extremely important. Improper orientation can cause extensive wear or damage. 1. Stagger the piston rings in the grooves until the end gaps are 120° apart. The oil ring rails should also be staggered. Figure 11-7. Installing #1 Piston. 5. Guide the lower end of connecting rod and rotate the crankshaft to join the two. Install the rod cap to the connecting rod using the two hex flange screws and torque in increments to 11.3 N·m (100 in. lb.) . See Figures 11-8 and 11-9. 11.3 11