Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly Figure 11-8. Attaching #1 Rod Cap. Figure 11-10. Installing Camshaft using Seal Protector. 2. Lubricate the camshaft bearing surfaces of the crankcase and camshaft with engine oil. Apply a small amount of grease to the lips of the oil seal. 3. Rotate the crankshaft and position the timing mark of the crankshaft gear at the 12 o'clock position. 4. Turn the governor cross shaft clockwise until the lower end of shaft contacts the crankcase (#1 side). Make sure the cross shaft remains in this position while installing the camshaft. Figure 11-9. Torquing #1 Rod Cap. 5.

Slide the camshaft into the bearing surface of the crankcase, positioning the timing mark of the camshaft gear at the 6 o'clock position. Make sure that the camshaft gear and crankshaft gear mesh, and the timing marks are aligned. See Figure 11-11. NOTE: Make sure to align the chamfer of the connecting rod with the chamfer of its mating end cap. When installed, the flat faces of the connecting rods should face each other. The faces with the raised rib should be toward the outside. 6. Repeat the above procedure for the other connecting rod and piston assembly. Install Camshaft 1. Inspect the edges of the camshaft keyway, make sure they are not nicked or burred.

Use a seal protector (11/16") to prevent damaging the seal lips, or dislodging inner spring when the camshaft is installed. Cellophane tape over the keyway is also recommended. See Figure 11-10. Figure 11-11. Timing Marks Aligned. 11.4