Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly Checking/Setting Camshaft End Play 1. Install the shim removed during disassembly onto the camshaft. Camshaft Shims White: 0.69215/0.73025 mm (0.02725/0.02875 in.) Blue: 0.74295/0.78105 mm (0.02925/0.03075 in.) Red: 0.79375/0.83185 mm (0.03125/0.03275 in.) Yellow: 0.84455/0.88265 mm (0.03325/0.03475 in.) Green: 0.89535/0.99345 mm (0.03525/0.03675 in.) Gray: 0.94615/0.98425 mm (0.03725/0.03875 in.) Black: 0.99695/1.03505 mm (0.03925/0.04075 in.) 2. Position the end play tool on the camshaft. 3. Apply pressure on the end play checking tool (pushing the camshaft toward the crankshaft). Use a feeler gauge to measure the end play between the shim and the end play tool.

See Figure 11-12. The camshaft end play should be 0.076/0.127 mm (0.003/0.005 in.) . Oil Pump Assembly The oil pump is mounted to the inside of the closure plate. If service was required, and the oil pump was removed, refer to the assembly procedures under "Oil Pump Assembly" in Section 10. Governor Assembly The governor assembly is located inside the closure plate. If service was required, and the governor was removed, refer to the assembly procedures under "Governor Assembly" in Section 10. Thrust Bearing, Washer and Shim Some specifications use a thrust bearing, thrust washer, and shim to control the end play of the crankshaft. See Figure 11-14.

If these items were noted during disassembly, make sure they were reinstalled in the proper sequence, as illustrated. A different procedure must be followed to check and adjust crankshaft end play on these models. Figure 11-12. Checking Camshaft End Play with Tool. 4. If the camshaft end play is not within the specified range, remove the original shim and reinstall the end play tool. Use a feeler gauge to determine the clearance between the camshaft and the tool. Subtract 0.100 mm ( 0.004 in ) from the measured clearance to obtain the required shim thickness. Refer to the table below and install the shim that matches the calculated thickness. See Figure 11-13.

Repeat steps 1-3 to verify that the correct end play exists. Figure 11-14. Thrust Bearing, Washer and Shim used on Some Models. Figure 11-13. Adding Shim for Camshaft. 11.5 11