Section 11 Reassembly The race for the thrust bearing presses loosely into the closure plate. If it is not already installed, push it into the crankshaft bore inside the closure plate. Pack the thrust bearing with heavy grease and stick the bearing into the race. Wipe some grease on the face of the thrust washer and stick it onto the thrust bearing. Wipe some grease on the face of the original shim and stick it onto the thrust washer. Closure Plate Oil Seal Install the closure plate onto the crankcase without applying RTV sealant and secure it with only two or three of the fasteners at this time. Use a dial indicator to check the crankshaft end play.
End play should be 0.070/0.590 mm (0.0027/0.0232 in.) . Shims are available in the five color-coded thicknesses listed below if adjustment is needed. Crankshaft End Play Shims BLUE 0.48-0.52 mm (0.050 mm Nominal) (0.019 in.) 8.0 mm (0.315 in.) Seal Depth BLACK 0.667-0.705 mm (0.686 mm Nominal) (0.27 in.) Figure 11-15. Oil Seal Depth in Closure Plate. Install Closure Plate Assembly RTV silicone sealant is used as a gasket between the closure plate and the crankcase. Refer to Section 2, of this manual for a listing of approved sealants. Always use fresh sealant. Using outdated sealant can result in leakage.
GREEN 0.8366-0.9127 mm (0.8750 mm Nominal) (0.34 in.) YELLOW 1.9652-1.1414 mm (1.1033 mm Nominal) (0.043 in.) RED 1.2938-1.3700 mm (1.3319 mm Nominal) (0.052 in.) 1. Be sure the sealing surfaces have been cleaned and prepared as described at the beginning of Section 10 or in Service Bulletin 252. Remove the closure plate. If end play requires adjustment, remove the original shim and install the appropriate size replacement. 2. Check to make sure that there are no nicks or burrs on the sealing surfaces of the closure plate or crankcase. Install Closure Plate Oil Seal 1. Check to make sure that there are no nicks or burrs in the crankshaft bore of the closure plate. 3.
Apply a 1/16" bead of sealant to the sealing surface of the closure plate. See Figure 11-16 for sealant pattern. 2. Apply a light coat of engine oil to the outside diameter of the oil seal. 3. Drive the oil seal into the closure plate using a seal driver. Make sure the oil seal is installed straight and true in bore to depth shown in Figure 11-15. 11.6