Section 11 Reassembly Testing the Engine It is recommended that the engine be appropriately secured and operated on a test stand or bench, prior to installation in the application. 4. Make sure the maximum engine speed does not exceed 3750 RPM (no load). Adjust the throttle, choke controls and high speed stop as necessary. Refer to the "Fuel System and Governor" section. 5. Place the throttle control into the "idle" or "slow" position and check the low idle speed (RPM). Refer to Section 5 if adjustment is required. 1. Make sure all hardware is tightened, and hose clamps are properly secured. 2. Set up the engine on a test stand. Install an oil pressure gauge.
Start the engine and check to be certain that oil pressure (20 psi or more) is present. Run for 5-10 minutes between idle and mid-range. 6. Stop the engine. 7. Recheck the oil and coolant levels. Oil level should be at the "F" mark on the dipstick, and the coolant level in the reservoir should be midway between the "ADD" and "FULL" marks. Add additional amounts as required. 3. Check all cooling system components and joint connections for leaks. 11.34