Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly 2. Fill the cooling system, through the radiator, with the coolant mix. Allow the coolant to drain into the lower areas. Fill the overflow reservoir midway between the "FULL" and "ADD" marks, then install the radiator and reservoir caps. See Figures 11-123 and 11-124. Figure 11-121. Installing Oil Filter. 4. Remove the oil fill cap from the valve cover. Fill the crankcase with new oil to the "F" mark on the dipstick. Refer to "Oil Type" and "Check Oil Level" on pages 6.1 and 6.2. Check oil level again after initial running. Always check the level with the dipstick before adding more oil. Push dipstick in completely. Figure 11-123. Radiator Cap (Install After Filling).

5. Reinstall the oil fill cap and tighten securely. See Figure 11-122. Figure 11-124. Coolant Reservoir with Coolant. Reconnect Battery and Spark Plug Leads Connect the leads to the spark plugs. Reconnect the positive (+) battery lead first, and the negative (-) lead last when connecting the battery. 11 Figure 11-122. Installing Dipstick and Oil Fill Cap. Install Coolant 1. Use equal parts of ethylene glycol (antifreeze) and water only. Distilled or deionized water is recommended, especially in areas where the water contains a high mineral content. Propylene glycol based antifreeze is not recommended. 11.33