Section 11 Reassembly 3. Align the lower flywheel cover with the #1 (starter) side lower radiator support bracket holes. Position the rectifier-regulator mounting plate, behind the cover and install the remaining two screws or nuts and flat washers. Torque the four fasteners to 9.9 N·m (88 in. lb.) . See Figure 11-120. If screws and Timmerman nuts/clips are used torque to 2.2-2.8 N·m (20-25 in. lb.) . Figure 11-118. Torquing Top Nuts on Upper Brackets. 9. If a "pulse" style fuel pump is used, install it to the tapped holes in the #2 side, upper radiator support bracket and torque the two screws to 6.8-7.3 N·m (60-65 in. lb.) .
Connect the outlet line between the pump and carburetor and the vacuum line to the crankcase fitting. Secure with the clamps. See Figure 11-119. Figure 11-120. Torquing Lower Screws and Rectifier-Regulator Mounting. 4. If removed, mount the rectifier-regulator to the plate with the two screws and attach the connector plug. See Figure 11-120. Install Muffler 1. Install new exhaust gaskets and attach the muffler and mounting hardware. Torque the screws to 9.9 N·m (88 in. lb.) . 2. Install the hex flange nuts to the exhaust studs. Torque the nuts to 24.4 N·m (216 in. lb.) . Figure 11-119. Fuel Line and Pump "Pulse" Fuel Pump. Install Oil Filter and Fill Crankcase with Oil 1.
Place a new oil filter in a shallow pan with the open end up. Pour new oil of the proper type through the threaded center hole. Stop pouring when the oil reaches the bottom of the threads. Allow a minute or two for the oil to be absorbed by the filter material. Install Lower Flywheel Cover, Rectifier-Regulator and Mounting Plate 1. Install/make sure the small metal spacers are positioned in the mounting holes of the lower flywheel cover. 2. Apply a thin film of oil to the rubber gasket on the new filter. 2. Attach the lower flywheel cover to the #2 (oil filter) side lower radiator support bracket, using two M6 screws and flat washers. Finger tighten only at this time. 3.
Install the new oil filter to the filter adapter. Turn the oil filter clockwise until the rubber gasket contacts the surface, then tighten the filter an additional 3/4-1 turn. See Figure 11-121. 11.32