Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Description Fuel Recommendations WARNING General Recommendations Purchase gasoline in small quantities and store in clean, approved containers. An approved container with a capacity of 2 gallons or less with a pouring spout is recommended. Such a container is easier to handle and helps prevent spillage during refueling. Explosive Fuel can cause fires and severe burns. Do not use gasoline left over from the previous season, to minimize gum deposits in your fuel system, and to ensure easy starting. Fuel system ALWAYS remains under HIGH PRESSURE. Do not add oil to the gasoline. WARNING: Explosive Fuel!

Gasoline is extremely flammable and its vapors can explode if ignited. Store gasoline only in approved containers, in well ventilated, unoccupied buildings, away from sparks or flames. Do not fill the fuel tank while the engine is hot or running, since spilled fuel could ignite if it comes in contact with hot parts or sparks from ignition. Do not start the engine near spilled fuel. Never use gasoline as a cleaning agent. Do not overfill the fuel tank. Leave room for the fuel to expand. Fuel Type Do not use leaded gasoline , as component damage will result. Any costs/damages incurred as a result of using leaded fuel will not be warranted.

Use only clean, fresh, unleaded gasoline with a pump sticker octane rating of 87 or higher. In countries using the Research method, it should be 90 octane minimum. The EFI fuel system remains under high pressure, even when the engine is stopped. Before attempting to service any part of the fuel system, the pressure must be relieved. Pressure tester, (part of EFI Service Kit, see Section 2) has an integral relief valve. Connect the black tester hose to the test valve in the fuel rail. Route the clear hose into a portable gasoline container. Depress the button on the tester relief valve.

Gasoline/Alcohol blends Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by volume) is approved as a fuel for Kohler EFI engines. Other gasoline/alcohol blends are not approved. Initial Starting/Priming Procedure Important: The EFI fuel system must be purged of air (primed) prior to the initial start up, and/or any time the system has been disassembled or the fuel tank run dry. Gasoline/Ether blends Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline blends (up to a maximum of 15% MTBE by volume) are approved as a fuel for Kohler EFI engines. Other gasoline/ether blends are not approved. 1. Turn the key switch to the “on/run” position.

You will hear the fuel pump cycle on and off. When the fuel pump stops cycling approximately one minute), the system is primed; start the engine. 5B.2