Section 5B EFI Fuel System EFI Fuel System Components The ECU controls the amount of fuel injected and the ignition timing by monitoring the primary sensor signals for engine temperature, speed (RPM), and throttle position (load). These primary signals are compared to preprogrammed “maps” in the ECU computer chip, and the ECU adjusts the fuel delivery to match the mapped values. An oxygen sensor provides continual feedback to the ECU based upon the amount of unused oxygen in the exhaust, indicating whether the fuel mixture being delivered is rich or lean. Based upon this feedback, the ECU further adjusts fuel input to re-establish the ideal air/ fuel ratio.
This operating mode is referred to as “closed loop” operation. The EFI system operates “closed loop” when all three of the following conditions are met: General The Electronic Fuel Injection (EFI) system is a complete engine fuel and ignition management design. The system includes the following principal components: Fuel Pump Fuel Filter Fuel Rail Fuel Line(s) Fuel Pressure Regulator Fuel Injectors Throttle Body/Intake Manifold Engine Control Unit (ECU) Ignition Coils Engine (Coolant) Temperature Sensor Throttle Position Sensor (TPS) Speed Sensor Oxygen Sensor Wire Harness Assembly & Affiliated Wiring, Malfunction Indicator Light (MIL) 5B a.
The engine (coolant) temperature is greater than 35°C (95°F). b. The oxygen sensor has warmed sufficiently to provide a signal (minimum 375°C, 709°F). Operation The EFI system is designed to provide peak engine performance with optimum fuel efficiency and lowest possible emissions. The ignition and injection functions are electronically controlled, monitored and continually corrected during operation to maintain the theoretical ideal or “stoichiometric” air/fuel ratio of 14.7:1. c. Engine operation is at a steady state (not starting, warming up, accelerating, etc.).
During “closed loop” operation the ECU has the ability to readjust temporary and learned adaptive controls, providing compensation for changes in overall engine condition and operating environment, so it will be able to maintain the ideal air/fuel ratio of 14.7:1. The system requires a minimum engine coolant temperature greater than 55°C (130°F) to properly adapt. These adaptive values are maintained as long as the ECU is “powered up” by the battery. The central component of the system is the Motronic Engine Control Unit (ECU) which manages system operation, determining the best combination of fuel mixture and ignition timing for the current operating conditions.
During certain operating periods such as cold starts, warm up, acceleration, etc., an air/fuel ratio richer than 14.7:1 is required, and the system operates in an “open loop” mode. In “open loop” operation the monitoring of exhaust gases (output) is not used, and the controlling adjustments are based on the primary sensor signals and programmed maps only. The system operates “open loop” whenever the three conditions for closed loop operation (above) are not being met. An electric fuel pump is used to move fuel from the tank through the fuel line and in-line fuel filter. A fuel pressure regulator maintains a system operating pressure of 39 psi and returns any excess fuel to the tank.
At the engine, fuel is fed through the fuel rail and into the injectors, which inject it into the intake ports. The ECU controls the amount of fuel by varying the length of time that the injectors are “on.” This can range from 1.5-8.0 milliseconds depending on fuel requirements. The controlled injection of the fuel occurs each crankshaft revolution, or twice for each 4-stroke cycle. One-half the total amount of fuel needed for one firing of a cylinder is injected during each injection. When the intake valve opens, the fuel/ air mixture is drawn into the combustion chamber, ignited, and burned. 5B.3