Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Important Service Notes! Cleanliness is essential and must be maintained at all times when servicing or working on the EFI system. Dirt, even in small quantities, can cause significant problems. Always disconnect negative (-) battery cable lead before charging battery, and also unplug harness from ECU before performing any welding on equipment. Electrical Components Clean any joint or fitting with parts cleaning solvent before opening to prevent dirt from entering the system. Electronic Control Unit (ECU) Always depressurize the fuel system through the test valve in fuel rail before disconnecting or servicing any fuel system components.

See fuel warning on page 5B.2. Never attempt to service any fuel system component while engine is running or ignition switch is . Do not use compressed air if the system is open. Cover any parts removed and wrap any open joints with plastic if they will remain open for any length of time. New parts should be removed from their protective packaging just prior to installation. Figure 5B-1. “32 Pin” (MSE 1.1) Plastic-Cased ECU. General A “32 Pin” (MSE 1.1) plastic-cased ECU is used on these engines. See Figure 5B-1. The ECU is the brain or central processing computer of the entire EFI fuel/ ignition management system.

During operation, sensors continuously gather data which is relayed through the wiring harness to input circuits within the ECU. Signals to the ECU include: ignition (on/off), crankshaft position and speed (RPM), throttle position, coolant temperature, exhaust oxygen levels, and battery voltage. The ECU compares the input signals to the programmed maps in its memory to determine the appropriate fuel and spark requirements for the immediate operating conditions. The ECU then sends output signals to set the injector duration and ignition timing. Avoid direct water or spray contact with system components.

Do not disconnect or reconnect the wiring harness connector to the control unit or any individual components with the ignition ‘‘on.’’ This can send a damaging voltage spike through the ECU. Do not allow the battery cables to touch opposing terminals. When connecting battery cables attach the positive (+) cable to positive (+) battery terminal first, followed by negative (-) cable to negative (-) battery terminal. Never start the engine when the cables are loose or poorly connected to the battery terminals. The ECU continually performs a diagnostic check of itself, each of the sensors, and the system performance.

If a fault is detected, the ECU turns on the Malfunction Indicator Light (MIL) on the equipment control panel, stores the fault code in its fault memory, and goes into a default operating mode. Depending on the significance or severity of the fault, normal operation may continue, or “limp home” operation (slowed speed, richer running) may be initiated. A technician can access the stored fault code using a “blink code” diagnosis flashed out through the MIL. An optional computer software diagnostic program is also available, see Section 2. Never disconnect battery while engine is running. Never use a quick battery charger to start the engine. Do not charge battery with key switch ‘‘on.’’ 5B.4