Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System The ECU requires a minimum of 7.0 volts to operate. The adaptive memory in the ECU is operational the moment the battery cables are connected, however the adapted values are lost if the battery becomes disconnected for any reason. The ECU will “relearn” the adapted values if the engine is operated for 10-15 minutes at varying speeds and loads after the coolant temperature exceeds 55°C (130°F). revolutions each time the engine is started. The sensor must be properly connected at all times. If the sensor becomes disconnected for any reason, the engine will quit running.

To prevent engine over-speed and possible failure, a “rev-limiting” feature is programmed into the ECU. If the maximum RPM limit (4500) is exceeded, the ECU suppresses the injection signals, cutting off the fuel flow. This process repeats itself in rapid succession, limiting operation to the preset maximum. Service Never attempt to disassemble the ECU. It is sealed to prevent damage to internal components. Warranty is void if the case is opened or tampered with in any way. Figure 5B-2. Engine Speed Sensor. Service The engine speed sensor is a sealed, non-serviceable assembly. If diagnosis indicates a problem within this area, check and test as follows.

All operating and control functions within the ECU are preset. No internal servicing or readjustment may be performed. If a problem is encountered, and you determine the ECU to be faulty, contact your source of supply. Do not replace the ECU without authorization. 1. Check the mounting and air gap of sensor. It must be 1.5 mm ± 0.25 mm (0.059 ± 0.010 in.) . The relationship between the ECU and the throttle position sensor (TPS) is very critical to proper system operation. If the TPS or ECU is changed, or the mounting position of the TPS is altered, the “TPS Initialization Procedure” (see pages 5B.7 and 5B.8) must be performed to restore the synchronization. 2.

Inspect the wiring and connections for damage or problems. 3. Make sure the engine has resistor type spark plugs. 4. Disconnect main harness connector from ECU. Engine Speed Sensor General The engine speed sensor is essential to engine operation; constantly monitoring the rotational speed (RPM) of the crankshaft. A ferromagnetic 60-tooth ring gear with two consecutive teeth missing is mounted on the flywheel. The inductive speed sensor is mounted 1.5 ± 0.25 mm (0.059 ± 0.010 in.) away from the ring gear. During rotation, an AC voltage pulse is created within the sensor for each passing tooth. The ECU calculates engine speed from the time interval between the consecutive pulses.

The two- tooth gap creates an interrupted input signal, corresponding to specific crankshaft position (84° BTDC) for cylinder #1. This signal serves as a reference for the control of ignition timing by the ECU. Synchronization of the inductive speed pickup and crankshaft position takes place during the first two 5. Connect an ohmmeter between pin terminals #9 and #10 in the plug. See chart on page 5B.24. A resistance value of 750-1000 Ω at room temperature (20°C, 68°F) should be obtained. If resistance is correct, check the mounting, air gap, toothed ring gear (damage, runout, etc.), and flywheel key. 6. Disconnect the speed sensor connector from wiring harness.

It is the connector with one heavy black lead (see Figure 5B-3). Viewing the connector as shown (dual aligning rails on top), test the resistance between the terminals indicated. A reading of 750-1000 Ω should again be obtained. 5B.5 5B