Section 5B EFI Fuel System Dual Aligning Rails Corresponds To #9 In Main Connector. Corresponds #10 In Main Connector. Test Terminals Figure 5B-3. Speed Sensor Connector. 1 2 3 7. a. If the resistance is incorrect, remove the screw securing the sensor to the mounting bracket and replace the sensor. b. If the resistance in step 2 was incorrect, but the resistance of the sensor alone was correct, test the main harness circuits between the sensor connector terminals and the corresponding pin terminals in the main connector. Correct any observed problem, reconnect the sensor, and perform step 5 again. 4 1. Throttle Valve Shaft 2. Resistor Track 3. Wiper Arm w/Wiper 4.
Electrical Connection Throttle Position Sensor (TPS) Figure 5B-4. Throttle Position Sensor Details. General The throttle position sensor (TPS) is used to indicate throttle plate angle to the ECU. Since the throttle (by way of the governor) reacts to engine load, the angle of the throttle plate is directly proportional to the load on the engine. Figure 5B-5. TPS Location. 5B.6