Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Mounted on the throttle body/intake manifold and operated directly off the end of the throttle shaft, the TPS works like a rheostat, varying the voltage signal to the ECU in direct correlation to the angle of the throttle plate. This signal, along with the other sensor signals, is processed by the ECU and compared to the internal pre-programmed maps to determine the required fuel and ignition settings for the amount of load. The correct position of the TPS is established and set at the factory. Do not loosen the TPS or alter the mounting position unless absolutely required by fault code diagnosis or throttle shaft service.

If the TPS is loosened or repositioned the “TPS Initialization Procedure” (see pages 5B.7 and 5B.8) must be performed to re-establish the baseline relationship between the ECU and the TPS. If the resistance values in steps 3, 4, and 5 are within specifications, go to step 6. If the resistance values are not within specifications, or a momentary short or open circuit was detected during rotation (step 4), the TPS needs to be replaced, go to step 7. 6. Check the TPS circuits (input, ground) between the TPS plug and the main harness connector for continuity, damage, etc., Pin Circuits #8 and #4. See chart on page 5B.24. 5B Service The TPS is a sealed, non-serviceable assembly.

If diagnosis indicates a bad sensor, complete replacement is necessary. If a blink code indicates a problem with the TPS, it can be tested as follows. a. Repair or replace as required. 1. Counting the number of turns, back out the idle speed adjusting screw (counterclockwise) until the throttle plate can be closed completely. b. Turn the idle speed screw back in to its original setting. c. Reconnect connector plugs, start engine and retest system operation. 2. Disconnect the main harness connector from the ECU, but leave the TPS mounted to the throttle body/manifold. 7. Remove the two mounting screws from the TPS. Save the screws for reuse. Remove and discard the faulty TPS.

Install the replacement TPS and secure with the original mounting screws. 3. Connect the ohmmeter leads as follows: (See chart on page 5B.24.) Connect the Red (positive) ohmmeter lead to #8 pin terminal, and the Black (negative) ohmmeter lead to #4 pin terminal. Hold the throttle closed and check the resistance. It should be 800-1200 Ω . a. Reconnect both connector plugs. b. Perform the “TPS Initialization Procedure” integrating the new sensor to the ECU. 4. Leave the leads connected to the pin terminals as described in step 3. Rotate the throttle shaft slowly counterclockwise to the full throttle position.

Monitor the dial during rotation for indication of any momentary short or open circuits. Note the resistance at the full throttle position. It should be 1800-3000 Ω . TPS Initialization Procedure “32 Pin” (MSE 1.1) Plastic-Cased ECU (Auto-Learn Initialization) 1. Check that the basic engine, all sensors, fuel, fuel pressure, and battery are good and functionally within specifications. 5. Disconnect the main wiring harness connector from the TPS, leaving the TPS assembled to the manifold. Refer to the following chart and perform the resistance checks indicated between the terminals in the TPS socket, with the throttle in the positions specified. Important! 2.

Remove/disconnect ALL external loads from the engine (belts, pumps, electric PTO clutch, alternator, rectifier-regulator, etc.). 5B.7 Throttle Position Between Terminals Resistance Value (Ω) Continuity Closed Closed Full Full Any 2 & 3 1 & 3 2 & 3 1 & 3 1 & 2 800-1200 1800-3000 1800-3000 800-1200 1600-2500 Yes Yes Yes Yes Yes