Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System 3. Locate the service connector plug in the wiring harness. To initiate the TPS auto-learn function, connect a jumper wire from the TPS initialization pin #24 (violet wire) to the battery voltage pin (red wire), or use a jumper connector plug with the blue jumper wire. See Figure 5B-6. If using the PC-based diagnostic tool and software (see Section 2), go to “Special Tests” and follow the prompts to complete. If the learn procedure was successfully completed, the external loads removed/disconnected in Step 2 may be reconnected. If the procedure was unsuccessful see Steps a. and b. following. a.

If during this procedure, the “MIL” goes back into blinking 4 consecutive blinks every 2 seconds, the engine and Oxygen sensor have cooled down and out of “closed-loop” operation, prohibiting the learning from occurring. Repeat Steps 5-8. b. If during the procedure with the engine running, the “MIL” stays “On” continuously, for more than 15 seconds, turn off the ignition. Then initiate the fault code sequence by doing three consecutive key-on/key-off cycles leaving the key “on” in the last sequence, (each key-on/key-off sequence must be less than 2.5 seconds long). The fault detected must be corrected before the “auto-learn” function of the ECU can be re- initiated.

The PC-based diagnostic tool and software may be used to read out the fault code and assist with the troubleshooting and repair. Figure 5B-6. Service Connector Plug. 4. Start the engine and immediately observe the Malfunction indicator Light (MIL). The light should start blinking 4 consecutive times every 2 seconds. Engine (Coolant) Temperature Sensor 5. Remove the jumper wire or plug from the service connector plug in wiring harness. 6. Run the engine at full throttle (above 3000 RPM), to warm up the engine and initiate O 2 sensor function in “closed-loop” operation. 7.

Watch the “MIL.” When the light starts blinking rapidly, (5 blinks per second), move the throttle lever to the low idle speed position. Check and adjust the idle speed to 1500 RPM , using a tachometer. The lamp should continue to blink rapidly for another 30 seconds before switching over to a slow blink. Figure 5B-7. Engine (Coolant) Temperature Sensor. 8. When the “MIL” blinks slowly, do not do anything but wait until the “MIL” shuts off. This indicates that this procedure has been completed successfully. 9. Shut off the engine. 5B.8