Section 5B EFI Fuel System General The engine (coolant) temperature sensor (Figure 5B-7) is used by the system to help determine fuel requirements for starting (a cold engine needs more fuel than one at or near operating temperature). Mounted in the throttle body/intake manifold, it has a temperature-sensitive resistor that extends into the coolant flow. The resistance changes with coolant temperature, altering the voltage sent to the ECU. Using a table stored in its memory, the ECU correlates the voltage drop to a specific temperature. Using the fuel delivery “maps”, the ECU then knows how much fuel is required for starting at that temperature.
Oxygen Sensor Service The coolant temperature sensor is a sealed, non- serviceable assembly. A faulty sensor must be replaced. If a blink code indicates a problem with the temperature sensor, it can be tested as follows. The oxygen sensor functions like a small battery, generating a voltage signal to the ECU, based upon the difference in oxygen content between the exhaust gas and the ambient air. 1. Drain coolant from system so level is lower than the coolant temperature sensor (approximately 1-1/2 qt.), then remove the sensor from the throttle body/intake manifold assembly. 2. Wipe sensor clean and allow it to reach room temperature (20°C, 68°F).
The tip of the sensor, protruding into the exhaust gas, is hollow (see cutaway Figure 5B-9). The outer portion of the tip is surrounded by the exhaust gas, with the inner portion exposed to the ambient air. When the oxygen concentration on one side of the tip is different than that of the other side, a voltage signal typically cycling between 0.2 and 1.0 volt is generated between the electrodes and sent to the ECU. The voltage signal tells the ECU if the engine is straying from the ideal 14.7:1 fuel mixture, and the ECU then adjusts the injector pulse accordingly. 3. Unplug the main harness connector from the ECU. 4.
With the sensor connected, check the coolant temperature sensor circuit resistance. Check between the #6 and #4 pin terminals. The resistance value should be 2375-2625 Ω . See chart on page 5B.24. 5. Unplug the sensor connector and check the sensor resistance separately. Resistance value should again be 2375-2625 Ω . 1 2 3 4 5 6 7 8 a. If the resistance is out of specifications, replace the temperature sensor and refill the cooling system. b. If it is within specifications, proceed to Step 6. 1. Connection Cable 2. Disc Spring 3. Ceramic Support Tube 4. Protective Sleeve 5. Contact Element 6. Sensor Housing 7. Active Ceramic Sensor 8. Protective Tube 6.
Check the temperature sensor circuits (input, ground) from the main harness connector to the corresponding terminal in the sensor plug for continuity, damage, etc. Pin circuits #6 and #4. Figure 5B-9. Cutaway of Oxygen Sensor. 5B.9 5B Figure 5B-8. Oxygen Sensor.