Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Throttle Body/Intake Manifold Assembly Adjustment Procedure 1. Make sure there are no fault codes present in the ECU memory. 2. Start the engine and allow it to fully warm up and establish closed looped operation (approximately 5-10 min.). 3. Place the throttle control in the ‘‘idle/slow’’ position and check the idle speed with a tachometer. Turn the idle speed screw in or out as required to obtain 1500 RPM , or the idle speed specified by the equipment manufacturer. 4. The low idle speed adjustment can affect the high speed setting. Move the throttle control to the full throttle position and check the high speed.

Adjust as necessary to 3750 RPM (no load), or the speed specified by the equipment manufacturer. Figure 5B-28. Upper Intake Manifold. General The EFI engines have no carburetor, so the throttle function (regulate incoming combustion airflow) is incorporated in the intake manifold assembly. The manifold consists of a one-piece aluminum casting which also provides mounting for the fuel injectors, throttle position sensor, fuel rail, air baffle, idle speed screw, and air cleaner assembly. Idle Speed Screw Service The throttle body/intake manifold is serviced as an assembly, with the throttle shaft, throttle plate, and idle speed adjusting screw installed.

The throttle shaft rotates on needle bearings (non-serviceable), capped with rubber seals to prevent air leaks. Idle Speed Adjustment (RPM) General The idle speed is the only adjustment that may be performed on the EFI system. The standard idle speed setting for EFI engines is 1500 RPM , but certain applications might require a different setting. Check the equipment manufacturer’s recommendation. Figure 5B-29. Idle Speed Screw Details. For starting and warm up, the ECU will adjust the fuel and ignition timing, based upon ambient temperature, engine temperature, and loads present. In cold conditions, the idle speed will probably be higher than normal for a few moments.

Under other conditions, the idle speed may actually start lower than normal, but gradually increase to the established setting as operation continues. Do not attempt to circumvent this warm up period, or readjust the idle speed during this time. The engine must be completely warmed up for accurate idle speed adjustment. Initial Governor Adjustment The initial governor adjustment is especially critical on EFI engines because of the accuracy and sensitivity of the electronic control system. Incorrect adjustment can result in overspeed, loss of power, lack of response, or inadequate load compensation.

If you encounter any of these symptoms and suspect them to be related to the governor setting, the following should be used to check and/or adjust the governor and throttle linkage. 5B.20