Section 5B EFI Fuel System Fuel Filter EFI engines use a high-volume, high-pressure, 10-15 micron, in-line fuel filter. fuel system pressure for servicing. The fuel supply line is attached to the barbed end of the fuel rail with an Oetiker hose clamp. Service The fuel rail is mounted to the throttle body/intake manifold. It can be detached by removing the two mounting screws and the injector retaining clips. Thoroughly clean the area around all joints prior to any disassembly. No specific servicing is required unless operating conditions indicate that it needs internal cleaning or replacement. Fuel Line Figure 5B-25. In-Line Fuel Filter.
Service Fuel filter replacement is recommended every 1500 hours of operation or more frequently under extremely dusty or dirty conditions. Use only the specified filter, and install it according to the directional arrows. DO NOT use a substitute filter as operating performance and safety can be affected. Relieve system pressure through the safety valve in the fuel rail before servicing. Fuel Rail Figure 5B-27. High Pressure Fuel Line. General Special low permeation high-pressure fuel line with an SAE30 R9 rating is required for safe and reliable operation, due to the higher operating pressure of the EFI system. If hose replacement is necessary, order Fuel Line Service Kit, Part No.
25 111 37-S (containing 60" of high-pressure hose and 10 Oetiker clamps), or use only the type specified. Special Oetiker clamps (Kohler Part No. 24 237 05-S ) are used on all fuel line connections to prevent tampering and safety hazards with the high fuel pressure. The old clamp must be cut to open a connection, so replacement is necessary each time. Oetiker Clamps Pliers (part of EFI Service Kit, see Section 2) is used to crimp the replacement clamps. Fuel Rail Figure 5B-26. Manifold Assembly. General The fuel rail is a formed tube assembly that feeds fuel to the top of the injectors. The tops of the injectors fit into formed cups in the fuel rail.
When the rail is fastened to the manifold, the injectors are locked into place. A small retaining clip provides a secondary lock. Incorporated into the fuel rail is a pressure relief/ test valve for testing operating pressure or relieving CAUTION: Fuel lines between the fuel pump and fuel rail must be made from SAE 30 R9 fuel line. Standard fuel line (SAE 30 R7) may only be used between the fuel tank and pump (5/16” ID) and for the return line from the pressure regulator to the tank (1/4” ID). All high-pressure fuel line connections must be secured with Oetiker clamps (Kohler Part No. 24 237 05-S), installed/crimped with the corresponding pliers. 5B.19 5B