Section 5B EFI Fuel System Pressure Regulating Spring Pressure Regulating Chamber Diaphragm Valve Valve Seat Fuel Chamber Outlet Port (to fuel rail) Return Port (to tank) Inlet Port Figure 5B-23. External Regulator and Base/Holder. Figure 5B-22. Fuel Pressure Regulator Details. Service Depending on the application, the regulator may be located in the fuel tank along with the fuel pump, or outside the tank just down line from the pump. The regulator is a sealed, non-serviceable assembly. If it is faulty, it must be separated from the base/holder assembly and replaced as follows. 1. Shut engine off, make sure engine is cool, and disconnect the negative (-) battery cable. 2.
Depressurize fuel system through test valve in fuel rail (see fuel warning on page 5B.2). Figure 5B-24. Internal Regulator and Base/Holder. 3. Access the regulator assembly as required and clean any dirt or foreign material away from the area. 5. Always use new O-Rings and hose clamps when installing a regulator. A new replacement regulator will have new O-Rings already installed. Lubricate the O-Rings with light grease or oil. 4. External Regulator Remove the retaining ring securing the regulator in the regulator housing. Pull the regulator out of the housing. See Figure 5B-23. 6. Install the new regulator by carefully pushing and rotating it slightly into the base or housing.
Internal (In-Tank) Regulator Remove the three screws securing the retaining ring and regulator in the base/holder assembly. Grasp and pull the regulator out of the base/ holder. See Figure 5B-24. 7. Secure with the retaining ring. Be careful not to dent or damage the body of the regulator as operating performance can be affected. 8. Reassemble any parts removed in step 3. 9. Reconnect the negative (-) battery cable. 10. Recheck the regulated system pressure at the fuel rail test valve. 5B.18