Section 5B EFI Fuel System Code: 55 Source: MIL (Diagnostic lamp) circuit open, shorted to ground, or shorted to battery. Explanation: MIL is not functioning because the circuit is open, shorted to ground, or shorted to battery. Expected Engine Response: Engine will run normally if no other errors are present. Code: 56 Source: Fuel pump relay circuit open, shorted to ground, or shorted to battery Explanation: Fuel pump, ignition coils, and fuel injectors will not function because the fuel pump relay circuit is either open, shorted to ground, or may be “on” continuously if shorted to battery. Expected Engine Response: Engine will not run, or fuel pump will continue to run when switch is off.
Possible Causes: 1. MIL (diagnostic lamp) related a. MIL element opened or element shorted to ground. b. Lamp missing. Possible Causes: 1. Fuel pump relay related a. Bad fuel pump relay. Primary side open or shorted. 5B 2. Engine wiring harness related a. Broken or shorted wire in harness. ECU pin 29 to lamp open or shorted. 2. Fuel pump related a. Fuel pump open or shorted internally. 3. Vehicle wiring harness related a. Broken or shorted wire in harness. Power lead to MIL open or shorted. 3. Engine wiring harness related a. Fuel pump fuse F1 open. b. Broken or shorted wire in harness. ECU pin 28 to fuel pump relay pin 86. Ignition switch to fuel pump relay pin 85. 4. ECU related a.
Circuit controlling lamp damaged. 4. ECU related a. Circuit controlling fuel pump relay damaged. Code: 61 Source: Explanation: Denotes the end of fault codes. If signaled first, no other fault codes are present. Troubleshooting Flow Chart The following flow chart provides an alternative method of troubleshooting the EFI system. The chart will enable you to review the entire system in about 10-15 minutes. Using the chart, the accompanying diagnostic aids (listed after the chart), and any signaled fault codes, you should be able to quickly locate any problems within the system. 5B.33