Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Code: 43 and 44 Source: TPS “Auto-Learn” initialization function failed, throttle angle out of learning range. Explanation: While performing the TPS “Auto- Learn” function the measured throttle angle was not within acceptable limits. Expected Engine Response: MIL illuminated. Engine will continue to run but not properly. Upon restart TPS Auto-Learn function will run again unless voltage to ECU disconnected to clear memory. 2. Engine wiring harness related a. Broken or shorted wire in harness. ECU pin 14 to injector pin 2. ECU pin 28 to fuel pump relay pin 86. Note: After key-off then key-on, code 56 would be set also. Fuel pump relay pin 87 to injector pin 1. b.

Open main fuse F1. 3. Fuel pump relay related a. Bad fuel pump relay. Primary side functional, but pin 30 to pin 87 remains open. Primary side pin 85 to pin 86 is either open, or shorted during engine operation. Note: After key-off then key-on, code 56 would be set also. Possible Causes: 1. TPS related a. TPS rotated on throttle shaft assembly out of allowable range. b. TPS bad. 4. ECU related a. Circuit controlling injector #1 damaged. b. Circuit controlling fuel pump relay damaged. Code: 52 Source: Injector #2 circuit open, shorted to ground, or shorted to battery. Explanation: Injector #2 is not functioning because the circuit is open, shorted to ground, or shorted to battery.

Expected Engine Response: Engine will run very poorly with only one cylinder functioning. 2. Engine wiring harness related a. Broken or shorted wire in harness. ECU pin 18 to TPS pin 1. ECU pin 4 to TPS pin 2. ECU pin 8 to TPS pin 3. 3. Throttle body related a. Throttle shaft inside TPS worn, broken, or damaged. b. Throttle plate loose or misaligned. c. Throttle plate bent or damaged allowing extra airflow past or restricting movement. Possible Causes: 1. Injector related a. Injector coil shorted or opened. 4. ECU related a. Circuit providing voltage or ground to TPS damaged. b. TPS signal input circuit damaged. 2. Engine wiring harness related a. Broken or shorted wire in harness.

ECU pin 15 to injector pin 2. ECU pin 28 to fuel pump relay pin 86. Note: After key-off then key-on code 56 would be set also. Fuel pump relay pin 87 to injector pin 1. b. Opened main fuse F1. Code: 51 Source: Injector #1 circuit open, shorted to ground, or shorted to battery. Explanation: Injector #1 is not functioning because the circuit is open, shorted to ground, or shorted to battery. Expected Engine Response: Engine will run very poorly with only one cylinder functioning. 3. Fuel pump relay related a. Bad fuel pump relay. Primary side functional, but pin 30 to pin 87 remains open. Primary side pin 85 to pin 86 is open or shorted during engine operation. Note:

After key-off then key- on code 56 would be set also. Possible Causes: 1. Injector related a. Injector coil shorted or opened. 4. ECU related a. Circuit controlling injector #2 damaged. b. Circuit controlling fuel pump relay damaged. 5B.32