Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System 2. Oxygen Sensor Related a. Sensor connector or wiring problem. b. Sensor contaminated or damaged. c. Exhaust leak. d. Poor ground path. e. Pin circuit #20 wiring or connectors. 3. Engine Wiring Harness Related a. Difference in voltage between sensed voltage (pin circuit 2) and actual injector voltage (circuit 45). b. Problem in wiring harness. c. ECU-to-harness connection problem. 3. TPS Sensor Related a. Throttle plate position incorrectly set or registered during “Initialization.’’ b. TPS problem or malfunction. 4. Systems Related a. Ignition (spark plug, plug wire, ignition coil. b. Fuel (fuel type/quality, injector, fuel pressure, fuel pump). c.

Combustion air (air cleaner dirty/restricted, intake leak, throttle bore). d. Base engine problem (rings, valves). e. Exhaust system leak (muffler, flange, oxygen sensor mounting boss, etc.). f. Fuel in the crankcase oil. g. Altitude. h. Blocked or restricted fuel return circuit to tank. 4. Engine Wiring Harness Related a. Difference in voltage between sensed voltage (pin circuit 2) and actual injector voltage (circuit 45). 5B 5. Systems Related a. Ignition (spark plug, plug wire, ignition coil. b. Fuel (fuel type/quality, injector, fuel pump, fuel pressure. c. Combustion air (air cleaner dirty/restricted, intake leak, throttle bores). d. Base engine problem (rings, valves). e.

Exhaust system leak. f. Fuel in the crankcase oil. g. Blocked or restricted fuel return circuit to tank. Code: 42 Source: Engine (Coolant) Temperature Sensor Explanation: Not sending proper signal to ECU. Expected Engine Response: Engine may be hard to start because ECU can’t determine correct fuel mixture. 6. ECU Related a. ECU-to-harness connection problem. Possible Causes: 1. Temperature Sensor Related a. Sensor wiring or connection. Code: 34 Source: Oxygen Sensor/Fuel System Components Explanation: Long term fuel adaptation control is at the upper or lower limit. Expected Engine Response:

System operates “closed loop.” No appreciable performance loss as long as the temporary adaptation can provide sufficient compensation. 2. Engine Wiring Harness Related a. Pin circuits 4, 6 and/or 4A damaged (wires, connectors) or routed near noisy signal (coils, alternator, etc.). b. ECU-to-harness connection problem. 3. System Related a. Engine is operating above the 176°C (350°F) coolant temperature sensor limit. b. ECU-to-harness connection problem. Possible Causes: 1. Oxygen Sensor Related a. Sensor connector or wiring. b. Sensor contaminated or damaged. c. Exhaust leak. d. Poor ground path. e. Pin circuit #20 wiring or connectors. 2. TPS Sensor Related a.

Throttle plate position incorrect during “Initialization” procedure. b. TPS problem or malfunction. 5B.31