Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Code: 23 Source: ECU Explanation: ECU is unable to recognize or process signals from its memory. Expected Engine Response: Engine will not run. the fuel mixture is suspect, probably incorrect TPS initialization or low fuel pressure. Possible Causes: 1. TPS Initialization Incorrect a. Lean condition (check oxygen sensor signal with VOA and see Oxygen Sensor section). Possible Causes: 1. ECU (internal memory problem). a. Diagnosable only through the elimination of all other system/component faults. 2. Engine Wire Harness Related a. Pin circuit #20 wiring or connectors. Code: 24 (will not blink out) Source: Engine Speed Sensor Explanation:

No tooth signal from speed sensor. MIL light will not go out when cranking. Expected Engine Response: None-engine will not start or run as ECU is unable to estimate speed. 3. Oxygen Sensor Related a. Sensor connector or wiring problem. b. Exhaust leak. c. Poor ground path to engine (sensor is case grounded). Code: 32 Source: Oxygen Sensor Explanation: No change in the sensor output signal. Expected Engine Response: “Open loop” operation only, may cause a drop in system performance and fuel efficiency. Possible Causes: 1. Engine Speed Sensor Related a. Sensor connector or wiring. b. Sensor loose or air gap incorrect. 2. Speed Sensor Wheel Related a. Damaged teeth. b.

Gap section not registering. Possible Causes: 1. Engine Wiring Harness Related a. Pin circuit #20 wiring or connectors. 3. Engine Wire Harness Related a. Pin circuit #9 and/or #10 wiring or connectors. 2. Oxygen Sensor Related a. Sensor connector or wiring problem. b. Sensor contaminated or damaged. c. Sensor below the minimum operating temperature (375°C, 709°F). d. Poor ground path to engine (sensor grounds through shell, see Oxygen Sensor section). 4. ECU/Harness Related a. ECU-to-harness connection problem. Code: 31 Source: Fuel Mixture or Oxygen Sensor Explanation: “System to Lean” Oxygen sensor not sending expected voltage to ECU. Expected Engine Response:

System operates under “open loop” control only. Until fault is detected and registered by ECU, engine will run rich if oxygen sensor is shorted to ground or lean if it is shorted to battery voltage. After fault is detected, performance can vary, depending on cause. If performance is pretty good, the problem is probably with the oxygen sensor, wiring, or connectors. If the engine is still running rich (laboring, short on power) or lean (popping or misfiring), Code: 33 Source: Oxygen Sensor/Fuel System Explanation: “System to Rich” Temporary fuel adaptation control is at the upper limit. Expected Engine Response: Erratic performance. Will run rich (smoke). Possible Causes: 1.

Fuel Supply Related (nothing lean – only rich) a. Restricted return line causing excessive fuel pressure. b. Fuel inlet screen plugged (in-tank fuel pump only). c. Incorrect fuel pressure at fuel rail. 5B.30