Section 5B EFI Fuel System Diagnostic Code Summary Code: 22 Source: Throttle Position Sensor (TPS) Explanation: Unrecognizable signal is being sent from sensor (too high, too low, inconsistent). Expected Engine Response: A “limp-home” operating mode occurs, with an overall decrease in operating performance and efficiency. Fuel delivery is based upon the oxygen sensor and five mapped values only. Rich running (black smoke) will occur until “closed loop” operation is initiated. A stumble or misfire on hard acceleration and/or erratic operation may be exhibited. Code: 21 Source: Engine Speed Sensor Explanation: ECU receiving inconsistent tooth count signals from speed sensor.
Expected Engine Response: Possible misfire as ECU attempts to resynchronize, during which time fuel and spark calculations are not made. Possible Causes: 1. Engine Speed Sensor Related a. Sensor connector or wiring. b. Sensor loose or incorrect air gap. c. Flywheel key sheared. 5B 2. Speed Sensor Ring Gear Related a. Damaged teeth. b. Varying gap (gear loose/out of alignment). Possible Causes: 1. TPS Sensor Related a. Sensor connector or wiring. b. Sensor output affected or disrupted by dirt, grease, oil, wear, or breather tube position (must be to side opposite the TPS). c. Sensor loose on throttle body manifold. 3. Engine Wire Harness Related a.
Pin circuits 9 and/or 10 wiring or connectors. b. Shielding for pin circuits 9 and/or 10 damaged or not properly grounded. c. Poor or improper grounds in system (battery, ECU, oxygen sensor, shielding, fuel pump, ignition output). d. Pin circuits 9 and/or 10 routed near noisy electrical signals (coils, spark plug lead, plug connector). 2. Throttle Body Related a. Throttle shaft or bearings worn/damaged. 3. Engine Wire Harness Related a. Pin circuits 4, 8, and/or 18 damaged (wiring, connectors). b. Pin circuits 4, 8, and/or 18 routed near noisy electrical signal (coils, alternator). c. Intermittent 5 volt source from ECU (pin circuit 18). 4. ECU/Harness Related a.
ECU-to-harness connection problem. 5. Ignition System Related a. Non-resistor spark plug(s) used. 4. ECU/Harness Related a. ECU-to-harness connection problem. 5B.29