Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System 5B.28 Diagnostic Code Summary Blink Code OBD2 P-Code Condition or Failure Description MIL Illuminated Note – – No RPM Signal Y 21 P0335 Loss of Synchronization Y 22 P0122 TPS - Open or Short Circuit to Ground Y 22 P0123 TPS - Short Circuit to Battery Y 23 P0601 Defective ECU Y 24 - Engine Speed Sensor Y 4 31 P0174 System too Lean Y 2 31 P0132 O Sensor Circuit: Shorted to Battery 2 Y 1 32 P0134 O Sensor Circuit: No Activity Detected 2 Y 33 P0175 System too Rich Y 3 33 P0020 O Sensor Control at Upper Limit 2 Y 34 P0171 Maximum Adaption Limit Reached Y 34 P0172 Minimum Adaption Limit Reached Y 42 P0117 Temperature Sensor Circuit:

Shorted to Ground Y 42 P0118 Temperature Sensor Circuit:

Open Circuit or Short to Battery Y 43 P1670 Failure Completing Autolearn - TPS Offset below minimum allowable limit Y 44 P1671 Failure Completing Autolearn - TPS Offset above maximum allowable limit Y 51 P1260 Injector 1 - Open Circuit Y 51 P0261 Injector 1 - Short Circuit to Ground Y 51 P0262 Injector 1 - Short Circuit to Battery Y 52 P1263 Injector 2 - Open Circuit Y 52 P0264 Injector 2 - Short Circuit to Ground Y 52 P0265 Injector 2 - Short Circuit to Battery Y 54 P0655 High Temperature Warning Lamp Circuit Open N 4 54 P1657 High Temperature Warning Lamp Circuit Shortened to Ground N 4 54 P1658 High Temperature Warning Lamp Circuit Shorted to Voltage N 4 55 P1651 MIL Lamp - Open Circuit N 55 P1652 MIL Lamp - Short Circuit to Ground Y 55 P1653 MIL Lamp - Short Circuit to Battery Y 56 P1231 Pump Relay - Open Circuit Y 56 P1232 Pump Relay - Short Circuit to Ground Y 56 P1233 Pump Relay - Short Circuit to Battery Y 58 P1480 Cooling Fan Driver Circuit Open N 58 P1481 Cooling Fan Driver Circuit Shorten to Ground N 58 P1482 Cooling Fan Driver Circuit Shorten to Voltage N 61 – End of Code Transmission N NOTE:

1. “O Sensor Short to Battery” diagnostic detection is disabled with SAS fuel-cutoff calibrated out. 2 2. “System too Lean” used to be “O Sensor - Short to Ground (P0131).” 2 3. “System too Rich” used to be “O Sensor Control at Lower Limit (P0019).” 2 4. Will not blink out. MIL Lamp is always switched OFF when failure is SPORADIC.